Open Workbench Logic Sniffer Case

Share

I bought a Open Workbench Logic Sniffer for a friend. This is a pretty cheap opensource logic analyzer which is very usefull for doing any electronics troubleshooting. As its very cheap, it only comes as a bare board without any case, but otherwise completly assembled. It looks like this:

As i wanted something nicer for my friend, i created a case for it. Thanks to Openscad and 3D printing technologies it was only some hours after i had this:

It was printed in colored PLA on my Rapman 3.1 in 0.25mm layer height. The multicolor feature was done with changeing the filament midprint, which works nicely if your are able to pause your printer and dont plan too many color changes.

As always you can find the model of this on thingiverse as thing 8235.

--------------

Domonoky

 

Leave your comments

Post comment as a guest

0
terms and condition.
  • No comments found